View single post by Bob R
 Posted: Mon May 21st, 2018 11:20 pm
PMQuoteReplyFull Topic
Bob R

Joined: Thu Nov 20th, 2014
Location: Springfield , Nebraska USA
Posts: 559
Really quite simple.
I use balsa for ties as it is soft before finishing.
I scrape the full length of a strip of balsa and then cut into tie lengths.
I use an exacto to further distress the ends for splits etc.
I glue them down with white glue.
After the glue has set I paint them with artists acrylic raw umber.
Then dry brushed with white.
Rails are glued in place with Walthers Goo (contact cement).
I add spikes but mostly for appearance only.
Rail sides are painted with Model Master acrylic Rust.
Finally rails are dry brushed with raw sienna.
I find that after paint and ballast glue etc the balsa ties are plenty strong.

Close Window