View single post by dan3192
 Posted: Fri Aug 24th, 2018 07:09 am
PMQuoteReplyFull Topic
dan3192

 

Joined: Thu Oct 14th, 2010
Location: Connecticut USA
Posts: 228
Status: 
Offline
(Note: To avoid confusion, this is an edited posting done after Post #20. Thank you Si for your help.)  

I received and reviewed information from TDK on coil selection, enough to start assembling a charging track. The problem was how to make a large hole in the E-Z Track for the Tx coil. I found a Forstner bit shown below at a Home Depot store which worked great.
 



Dan

Last edited on Fri Aug 24th, 2018 06:35 pm by dan3192

Close Window