View single post by dan3192
 Posted: Sun Oct 14th, 2018 01:45 am
PMQuoteReplyFull Topic
dan3192

 

Joined: Thu Oct 14th, 2010
Location: Connecticut USA
Posts: 228
Status: 
Offline
The coil was difficult to work with. I tried to solder wires to the coil leads several times without success. I wound up using crimping pins and a pair of connectors to make a lead wire for the coil.

A rubber plug and some Kapton tape holds the coil against the bottom of the rails.

Dan




Last edited on Sun Oct 14th, 2018 01:46 am by dan3192

Close Window