View single post by dan3192
 Posted: Thu Nov 22nd, 2018 05:43 pm
PMQuoteReplyFull Topic
dan3192

 

Joined: Thu Oct 14th, 2010
Location: Connecticut USA
Posts: 228
Status: 
Offline
I've done a little homework on my own questions, so will finish up on the wiring and check it out.

For the 1S arrangement, the receiver coil will be connected to the battery pcb via the run/off-charge switch. The pcb should receive around 5V which should be OK from what I've read. For the 2S setup, a VR will be used to boost the voltage to 9V, which also appears to be OK.

The engine is half wired and a little tricky to do since I'm modifying existing wiring instead of starting from scratch.


Dan     

Close Window