View single post by dan3192
 Posted: Sun Dec 23rd, 2018 03:50 am
PMQuoteReplyFull Topic
dan3192

 

Joined: Thu Oct 14th, 2010
Location: Connecticut USA
Posts: 228
Status: 
Offline
A little more rework on the GP35 road switcher. The old 5V voltage regulator was removed and replaced with a Pololu 2116 9V regulator just to the left of the switch. Pretty small device. The wire over it is the negative for the system. The assembly will go back on top of the battery.

Below that is a 1S battery management board and a receiver coil with its electronics for charging the Li-ion battery, which will go under the fuel tank. This is a rewire of the original arrangement to confirm the feasibility of on-board induction charging.

Doing this so I don't have to remove the battery for charging. 

Dan


Last edited on Sun Dec 23rd, 2018 03:51 am by dan3192

Close Window