View single post by Geoff L
 Posted: Tue Oct 22nd, 2019 06:09 pm
PMQuoteReplyFull Topic
Geoff L

 

Joined: Tue Nov 4th, 2014
Location: Hemel Hempstead, United Kingdom
Posts: 56
Status: 
Offline

Claus

I originally had problems with Prog4 using CoolTerm,
and tried your program with equal lack of success!


Subsequently I changed the Baud rate, and got the correct response.
(There is a label covering the back of the Prog4, sealed within shrink wrap).

However, writing the changes get an OK response,
the changes are not effected to the Rx.


I have Rx 105 controlled through 2 MUX boards.
and I am trying to change pins 3&4 (1,3,1,6) and (1,4,1,4).

I am getting 3 flash on Prog4 and Rx,
so wonder what I have missed.


Do you have any suggestions, please?

Geoff


Close Window