|View single post by Andy R|
|Posted: Sun Dec 15th, 2019 11:08 pm||
The paper-clip reset doesn't clear bind data,
only receiver programming.
If you made any changes to an output function,
hard-reset will return the behaviour to the as-shipped configuration.
As you are using a Tx20,
you need to have Selecta disabled.
One of the Tx20 function buttons
( which one depends on whose Tx20 you are using,
look at the information sheet that came with the Tx2 )
operates R/C channel 2, which is the same as used by Tx22 etc, for Selecta.
So, if you enable Selecta on the receiver,
you will find it getting deselected when you push the Tx20 button.