View single post by GoodNPlenty
 Posted: Fri Feb 5th, 2010 05:52 am
PMQuoteReplyFull Topic
GoodNPlenty

 

Joined: 
Location:  
Posts: 
Status: 
Offline
[:Crazy: WARNING: THINKING OUT LOUD AGAIN!]

NEON CHEAT and BACK-LIT SIGN:

While the etched panel is most effective for the "backless" neon signs, If you're going to add a back panel and the exterior appearance is much more important than seeing the interior, you may consider the following "cheat" for neon or use it for a back-lit sign.

Take a piece of 1/8" plexiglass and drill a hole or 2 in the side edge(s) to insert small bright white LED's Option: file the tip of the LED flat and glue to flat edge.

Paint everything white EXCEPT the front surface, then flat black, and if you like, white again (most light boxes seem to be white)

In your favorite graphics program:

For Neon -
a. Create your neon masterpiece and invert it so the background is black and the "neon" is clear and flip it backwards so the printing will be on the back surface.
  For multi-color, do everything together as clear.
b. Print it on a laser transparency. Cut it out.
 
c. Use Sharpie's to add color by hand. It's easy since everything is masked in black. For white, you can either apply nothing, or engrave those areas to diffuse the light right at that area. If you get light bleeding through the black printed mask, print another copy unflipped, and add it behind so the two print sides face each other. It's not a bad idea to plan on this insurance. It also enhances the look if you engrave the whole graphic in the front side.


For Back-Lit Picture -
a. Color laser or inkjet print your pretty picture on the thinnest white paper your printer can handle. Or Color Laser onto transparency and sand the back side to diffuse light. Sand side to side as well as up and down.

b. "Laminate" the front of it with REAL shiny clear tape (none of the magic crap). Burnish the tape down real good and cut it out.


Spray the back of your masterpiece with tack spray and install it on your light box.

An alternative for simple neon is to use the transparency for the window with the graphic printed on it and "Sharpie" the colors in or cut pieces of colored lighting gels you can get at most music stores these days. Then stick a sheet of frosted gel or simply sand a piece of transparency and stick it behind the graphic. Mount a bright white LED in the ceiling of the room behind the sign and aim it at the sign.

For more realism, you can make up this type of neon sign separately from the window and carefully superglue clear mono-filament "thread" or fish line, if you can find something thin & clear enough for your scale, over the flat "neon". Tiny flecks of silver and black paint will create the little mounting brackets that hold the glass tube and the sections that are blacked out between letters.

If you have a good temperature controlled solder iron, you should be able to dial in a temperature just warm enough to relax the mono' for bending and actually form the neon.


Later,
Steve Z

:thumb: Somebody let me know if any of this BS works so I can try it!


Close Window