View single post by smokebox
 Posted: Sat Aug 25th, 2012 02:23 am
PMQuoteReplyFull Topic
smokebox

 

Joined: 
Location:  
Posts: 
Status: 
Offline

 

   This picture shows the C channel glued on after I shortened the floor supports. I didn't make any attempt to sand them at an angle at all, I simply cut them with the Dremel cut off wheel fluse with the bottom of the floor then cut them at a 90* angle.

  Now that I'm sober I think I will take all the inner ribs out and leave just the truck bolsters.

"NOTE"....... model  building under the influence can get expensive!!!

Also, remember I am not trying to build an exact copy of the prototype,it is just based on the over all shape.

 

Rob

Last edited on Sat Aug 25th, 2012 02:26 am by

Close Window