View single post by dtsteam
 Posted: Mon Apr 21st, 2014 07:32 am
PMQuoteReplyFull Topic
dtsteam



Joined: Sat Oct 13th, 2012
Location: Preston, United Kingdom
Posts: 22
Status: 
Offline
Bill Fornshell wrote:

I need to figure out how to get at the wiring for the motor so I can remove the wheel pickups and run wires from a RC Receiver to the motor. I will probably ruin one motor learning how to do this.


I think you just have to take the two screws out, and the plastic molding on top of the pickups just lifts off. The pickups themselves are pressed into little plastic pips, and again just lift out. I can't remember whether the motor is soldered in, but still, you should be able to get at it without much harm. My problem now is keeping the pickups in place without the plastic shell !



____________________
David
Close Window