View single post by Helmut
 Posted: Sun Apr 23rd, 2017 10:25 pm
PMQuoteReplyFull Topic
Helmut



Joined: Sun Feb 17th, 2013
Location: Friedberg, Germany
Posts: 1076
Status: 
Offline
@Herb

That brickwork is "Faller" # 222559   ( intended for N scale, but actually just right for TT )

Brickwork - you can make it by gouging Bristol-Board like I did below.
The dimensions are exact for TT scale -2.1 x 0.9 mm and a 0.1 mm mortar layer.
But this is only for rather small detailed areas IMHO.
Honestly, the plotter wouldn't mind- it just takes some time to finish.
That particular specimen was made on a Portrait.
I used it to simulate old, partially crumbling work.
The three-dimensional surface comes out when you rub off the fuzz left from gouging with an abrasive sponge.







____________________
Regards, H.
Close Window