Freerails Home 

Freerails IS ACCEPTING new Members ... To join Freerails ... See how to Register as a Member in the 'Joining Freerails' Forum

 Moderated by: .  
AuthorPost
2foot6
Registered


Joined: Sun Oct 20th, 2013
Location:  Victoria, Australia
Posts: 431
Status: 
Offline
 
I have an MRC sounder decoder that has a strange problem.

After pressing the horn a few times, the decoder seems to have remapped a lot of the sounds.

Pressing different F. buttons sounds the wrong sounds and the decoder is difficult to program.

If I increase the speed, the decoder changes the sounds of the engine to different loco engine sounds,
and back again when I decrease the speed.

Is there a reset code apart from CV125-1 (that only resets some CVs) ?
I need to fully default the decoder to it's original settings, including the CV settings we don't know about ?

.................frustrated

Peter.


slateworks
Registered


Joined: Wed Oct 6th, 2010
Location: Twickenham, United Kingdom
Posts: 1052
Status: 
Online
Why not go to the horse's mouth for a definitive answer. I've found them very helpful in the past.

https://www.modelrectifier.com/dccdecoders-s/112.htm

Last edited on Wed Aug 1st, 2018 12:56 pm by slateworks

2foot6
Registered


Joined: Sun Oct 20th, 2013
Location:  Victoria, Australia
Posts: 431
Status: 
Offline
Thanks for that Doug,I have already emailed them,still waiting for a response........Peter


UltraBB 1.172 Copyright © 2007-2016 Data 1 Systems