|View single post by Steve P|
|Posted: Sun May 2nd, 2021 02:53 pm||
I also asked this question in my 'Track Planning' Forum Thread.
I've been re-designing the turnout motor control board,
with knowledge I obtained from using the prototype version.
Testing turnout control,
I've realized that I need a spring/latch mechanism of some sort,
to hold a turnout firmly in its set position.
I'm using LGB G-scale turnouts,
the manual spring mechanism just isn't firm enough to hold it in position,
once I turn off servo power after the movement.
Has anyone seen a product or design for such a mechanism,
that they would recommend?
Beaver Lode Railway