 | PM |  | | Quote | | | Reply | | | Full Topic | |
| Joined: | Mon Oct 1st, 2018 |
| Location: | Portland, Oregon USA |
| Posts: | 281 |
| Status: |
Offline
|
So next I drilled, and added truss rods, from provided wire.
Kinda tricky to get angle and nut/bolt/washer castings in
(tiny town, and these aren't even the small ones).
Added small pieces of paper,
to represent washers between bolster supports,
and then added smaller NBW castings to areas required.
Attachment: RGS 02 6.jpeg (Downloaded 57 times)
____________________
mikel
| Close Window | |