View single post by Ray Dunakin
 Posted: Sun Oct 13th, 2013 11:38 pm
PMQuoteReplyFull Topic
Ray Dunakin

 

Joined: Wed Jul 25th, 2012
Location: San Diego
Posts: 1243
Status: 
Offline
More progress... I'm finally getting to the fun part: painting!

I started by coating the exterior of the building with the same concrete-colored exterior latex paint that I used on my previous building:




Then I made a couple small, flat stamps out of scraps of Sintra PVC. The larger one is about .5" x 1.75". The smaller one is about 5/8" long and less than an half inch wide:




I used a paint brush to apply a thin layer of paint to the face of the stamp. Then I press it down onto the brick surface. The paint sticks to the raised face of the bricks, defining their shape. The smaller stamp was used to get into narrow places:






Obviously it doesn't cover everything, especially on the "decayed" bricks, and so there is a lot of touching up that has to be done using a fine brush. Still, it beats painting each brick one by one.

Here's a close up shot of the bricks after touching up:




The upper portion of the side walls has a small section of bricks which will be visible above the adjoining buildings. As you may recall, I had used automotive spot putty to smooth the joints, which caused problems when I tried to scribe the lines using the custom tools I made. What I ended up doing was using a carbide tipped metal scribe, and going over it fairly lightly to avoid crumbling the putty. The photo below shows how it turned out. It's not great but it'll do. It'll look better after I touch up the paint in the mortar lines do a few other little things:




Here are a couple shots of the building in progress, setting on the foundation:






More to come... Enjoy!

Last edited on Sun Oct 13th, 2013 11:51 pm by Ray Dunakin



____________________
Visit http://www.raydunakin.com to see photos of the rugged and rocky In-ko-pah Railroad!
Close Window