 | PM |  | | Quote | | | Reply | | | Full Topic | |
| Joined: | Fri Jul 28th, 2017 |
| Location: | |
| Posts: | 3 |
| Status: |
Offline
|
| Close Window | |
| View single post by Clint Rudesill | |||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Posted: Wed Aug 9th, 2017 01:42 am |
|
||||||||||||
Clint Rudesill
|
I installed the Digitrac AR1 and it works fine when loco goes around one direction, but if I start loco the other direction first it shorts out as it finishes the reversing section. I'm confused, too much current or too little? Or something else. Clint
|
||||||||||||
| |||||||||||||